Cd Mechanism Section - JVC KD-S733R Service Manual

KD-S733R/KD-S731R
<CD mechanism section>
Removing the CD mechanism control
board (See Fig.1 and 2)
1.
Unsolder the part a and b on the CD mechanism
control board.
2.
Remove the stator fixing the CD mechanism control
board and the damper bracket (To remove the stator
smoothly, pick up the center part).
3.
Remove the screw A attaching the CD mechanism
control board.
4.
Remove the CD mechanism control board in the
direction of the arrow while releasing it from the two
damper bracket slots d and the front bracket slot e.
5. Disconnect the flexible wire from connector on the
pickup unit.
ATTENTION: Turn the FD gear in the direction of the
arrow to move the entire pickup unit to
the appropriate position where the
flexible wire of the CD mechanism unit
can be disconnected easily.
Removing the loading motor
Prior to performing the following procedure, remove
the CD mechanism control board.
1. Remove the two springs f attaching the CD
mechanism assembly and the front bracket.
2. Remove the two screws B and the front bracket
while pulling the flame outward.
3. Remove the belt and the screw C from the loading
motor.
Loading motor
1-8
(Refer to Fig.2)
(See Fig.3 to 5)
C
Belt
Fig.5
CD mechanism assembly
D
h
Front bracket
Pickup unit
FD gear
CD mechanism control board
f
B
Loading motor
Pull outward
Flame
Damper bracket
D
a
h
c
D
d
CD mechanism
e
A
control board
b
Fig.1
Flexible wire
Shift the lock
Fig.2
f
B
Front bracket
Fig.3
Front bracket
Pull outward
Fig.4