Connection Methods; Quick Config (Automatic Setup) - Yamaha Tio1608-D Owner's Manual

Connection methods

This section explains the different methods for connecting
the Tio1608-D to other Dante devices.

Quick Config (automatic setup)

When connecting the unit to a TF series mixing console,
Quick Config makes it easy to set up the unit automatically.
It allows you to connect up to three Tio1608-D units to one
TF series mixing console, and configures Dante network
settings and audio signal settings in one operation.
NOTE
An NY64-D audio interface card (sold separately) is required to
connect a Tio1608-D to a TF series mixing console.
Tio1608-D procedure
1. With all the units turned off, set the DIP switches on
the rear panel to the up position.
2. Set the [QUICK CONFIG] switch on the front panel
to the [ON] position.
3. Set the [UNIT ID] switch on the front panel to the
desired position.
If you are using multiple Tio1608-D units, make sure
each unit has a unique UNIT ID setting.
4. Use Ethernet cables to connect the Tio1608-D to the
NY64-D card (installed in the TF series mixing
console) or to other Tio1608-D units in a daisy-
chain configuration, as shown below.
When using Quick Config, the units will operate the same
whether you connect the Ethernet cables to the [PRIMARY] or
[SECONDARY] Dante connector.
When connecting 3 units
5. Turn each device on.
TF series mixing console procedure
6. Display the console's SYSTEM SETUP  SLOT SETUP
screen, and confirm that Quick Config is enabled.
Now the TF series mixing console can recognize the
Tio1608-D units, and all Dante settings and input and output
patching settings will be configured automatically.
When the Quick Config button is displayed in white, Quick
Config is enabled. If the button is grayed out, click it. If you
cannot enable Quick Config, return to step
the Tio1608-D is configured properly.
- 13 -
Connection methods
[PRIMARY] or
[SECONDARY]
connector
TF Series (NY64-D)
[PRIMARY]
connector
[SECONDARY]
connector
Tio1608-D UNIT ID=1
[PRIMARY]
connector
[SECONDARY]
connector
Tio1608-D UNIT ID=2
[PRIMARY] or
[SECONDARY]
connector
Tio1608-D UNIT ID=3
1
and confirm that
Tio1608-D Owner's Manual