Pioneer DVR-745H-S Operating Instructions Manual page 54

06 Playback
Playing Video CD/Super VCDs
The table below shows the basic playback
controls for Video CD/Super VCDs.
Some discs feature Playback Control (PBC
for short) menus. These discs show PBC in
the display when you load them and display
a menu on-screen from where you can select
what to watch.
Press to start playback.
PLAY
Video CD only: If RESUME is dis-
played on-screen, playback
starts from the place last
stopped.
Press to stop playback.
STOP
Video CD only: You can resume
playback from the same point
by pressing
STOP again to cancel the
resume function.)
Pauses playback, or restarts
PAUSE
playback when paused.
Press to start scanning. Press
REV SCAN FWD SCAN
repeatedly to increase the scan-
ning speed.
Press to skip to previous/next
PREV NEXT
track.
When a PBC menu is dis-
played, press to display the pre-
vious/next page. (During
playback you can also use the
front panel CH +/– buttons.)
During playback, enter a track
ABC DEF
number then press ENTER to
GHI JKL MNO
skip directly to that track.
PQRS TUV WXYZ
Press CLEAR to clear a number
CLEAR
entry and start again.
CLEAR
While a PBC menu screen is
displayed, use to select num-
ENTER
bered menu items.
Note
1 When playing in PBC mode, some playback features, such as search, repeat and program play are not avail-
54
able. You can play a PBC Video CD/Super VCD in non-PBC mode by starting playback using the Disc Navigator
(see Using the Disc Navigator with playback-only discs on page 56).
En
1
PLAY. (Press
Video CD only: Each press skips
CM
BACK SKIP
backward/forward progressively
up to a maximum of ten min-
utes forward or three minutes
back. Note that this function
doesn't work when playing in
PBC mode.
Press to start slow-motion play-
STEP/SLOW
back. Press repeatedly to
change the playback speed (for-
ward only).
While paused, press to advance
a single frame (forward only).
Press to display the disc menu
RETURN
of a Video CD/Super VCD play-
ing in PBC mode.