Pioneer DVR-745H-S Operating Instructions Manual page 47

Recording
Important
• It takes a little while for this recorder to
switch on and start recording after
detecting a signal. Please bear this in
mind when setting the timer.
• If Auto Start Recording is set, it will not
start if another timer recording is in
progress.
• Timer recordings take precedence over
Auto Start Recording. Auto Start
Recording will stop if a timer recording is
due to start. After the timer recording
has finished, Auto Start Recording will
resume.
1 Set the timer for the satellite receiver
(or other component), then switch it into
standby (if necessary).
Check the manual that came with the
receiver if you're not sure how to do this.
2 Check that the 'Audio In' settings for
'External Audio' and 'Dual Mono
Recording/Bilingual Recording' are as
you want them.
See Audio In on page 108 for more on these
settings.
3 Set up the recorder.
• Use REC MODE to set the recording
quality. See Setting the picture quality/
recording time on page 36 for detailed
information.
4 Press HOME MENU and select 'Timer
Recording', then 'Auto Start Recording'.
5 Select 'Yes' to switch Auto Start
Recording on, or 'No' to switch off.
If you choose 'Yes' the recorder
automatically goes into standby.
The AUTO indicator in the front panel
display lights.
The recorder will automatically switch on
and start recording when the other
component comes on. Recording stops
when the external component switches off.
• To cancel Auto Start Recording, press
STANDBY/ON while the recorder is in
standby. The AUTO indicator goes off.
• To cancel Auto Start Recording once
recording has already started, press
REC for three seconds (this cancels Auto
Start Recording, but recording
continues), then
recording.
• You can also stop recording by pressing
STOP REC then selecting Yes to
confirm.
Tip
• Alternatively, with no OSD displayed,
press and hold the front panel STOP REC
button for more than three seconds to
switch Auto Start Recording on directly.
After switching on, switch the recorder
into standby.
STOP REC to stop
05
47
En