Download Print this page

Eu Compliance Information; Weee Notice - Klipsch X20i Owner's Manual

In-ear

Advertisement

OSHA GUIDELINES FOR NOISE EXPOSURE
LIMITS
Sound
i
Recommended
I
Pressure
I
Maximum Exposure
I
I
Level
I
Per Day
I
I
90dB
I
I
8 Hours
I
92d8
I
6 Hours
I
l
95dB
I
4 Hours
I
I
97dB
I
I
I
3 Hours
100dB
I
2 Hours
i
I
102dB
I
1.5 Hours
I
I
105dB
I
1 Hours
I
110dB
30 Minutes
115d8
I
15 Minutes or less
120dB
I
Avoid as damage may
_L
occur
EU COMPLIANCE INFORMATION
Eligible to bear the CE mark; Conforms
to European Union Low Voltage Directive
2006/95/EC; European Union EMC
Directive 2004/108/EC; European Union
RoHS Directive 2002/95/EC; European
Union WEEE Directive 2002/96/EC;
European Union Registration, Evaluation,
Authorization and Restriction of
Chemicals (REACH) Directive 2006/121/EC.
"er
WEEE NOTICE
~
Note: This mark applies only to
-
countries within the European
Union (EU) and Norway.
This appliance is labeled in accordance
with European Directive 2002/96/
EC concerning waste electrical and
electronic equipment (WEEE). This label
indicates that this product should not
be disposed of with household waste. It
should be deposited at an appropriate
facility to enable recovery and recycling.
FCC AND CANADA EMC COMPLIANCE
INFORMATION
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation.
This equipment generates, uses and can
radiate radio frequency energy and, if
not in-stalled and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on

Advertisement

loading