Removing The Transport Bolts; Water Supply - Bosch WAE24280MY Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Installation and connection
en

Removing the transport bolts

Caution!
The appliance may be damaged!
Transport bolts which have not been
removed may damage the drum or
other components while the washing
machine is running. Before using the
appliance for the first time, make sure
that all four transport bolts are
completely removed. Keep the bolts in a
safe place.
Caution!
The appliance may be damaged!
To prevent damage in transit when
transporting the appliance at a later
date, always re-install the transport bolts
prior to transportation.
To avoid injury, take care when
Note:
handling these.
Use a spanner to loosen all fixing
1.
bolts until they turn freely.
All four parts will fall to the floor
2.
when you tip the machine.
Insert the covers which you will find
3.
in the bag containing the
documentation.
28

Water supply

:
Warning
Danger of death from electric shock!
Danger of death if live parts are
touched.
Notes
To prevent leakage or water
damage, follow the instructions in
this section!
Operate the machine with cold
drinking water only. Do not connect
to the mixer tap of an unpressurised
hot-water apparatus.
Do not remove the water inlet hose
frequently as the loose connection
will lead to leaks. We recommend
that you use a water inlet hose that is
specially made for the machine.
Use only the supplied inlet hose or a
new one purchased from an
authorised specialist retailer, not a
used one!
If in doubt, have the appliance
connected by a technician.
Water inlet hose: do not kink,
Note:
crush, modify or sever (its strength is no
longer guaranteed).
Optimum water pressure in the mains:
100-1000 kPa (1-10 bar)
When the tap is turned on, the water
flow is at least 8 l/min.
If the water pressure is higher, install
a pressure reducing valve.
Connect the water inlet hose (_" =
1.
26.4mm).
:
Warning
The threads for the screw
connections may be damaged!
If the screw connections are
tightened too tightly using a tool
(pliers), the threads may be
damaged.
Tighten plastic screw-fittings by hand
only.

Advertisement

Table of Contents
loading

Table of Contents