Before Washing For The First Time; Transportation, E.g. When Moving House - Bosch WAE24280MY Instruction Manual And Installation Instructions

Before washing for the first
time
The washing machine was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum clean programme the first time
without any laundry.
The washing machine must have
Note:
been installed and connected properly.
See the Installing section.~ Page 26
Check the machine.
1.
Never switch on a damaged
Note:
machine. Inform your customer
service. ~ Page 24
Plug into the mains.
2.
Turn the tap on.
3.
Switch on the appliance.
4.
Close the washing machine door.
5.
Do not load any laundry.
Select the Drum clean programme.
6.
Open the detergent drawer.
7.
Pour approx. 1 litre of water into
8.
dispenser II.
Add standard detergent to
9.
dispenser II according to the
manufacturer's instructions for light
soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
standard or mild detergents.
Close the detergent drawer.
10.
Select Start/Reload.
11.
When the programme ends, switch
12.
off the appliance.
Your washing machine is now ready
for use.
Installation and connection
Transportation, e.g. when
moving house
Before transporting the washing
machine:
Turn off the tap.
1.
Release the water pressure in the
2.
water inlet hose.~ Page 22
Drain any residual detergent
3.
solution.~ Page 21
Pull out the mains plug.
4.
Remove the hoses.
5.
Installing the transport bolts:
Remove four covers and the rear cover.
Insert and tighten the transport bolts.
Before switching on the appliance:
Notes
Always remove the transport
■
bolts!~ Page 28
To prevent unused detergent from
■
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser II and start the 0 Spin
programme.
en
31