Time And Date Of System Setup; How To Apply The Wrist Cuff - BRASH IMPORTS 3000 Instruction Manual

TIME AND DATE OF SYSTEM SETUP

1. Press "POWER" key to enter the measurement mode.
2. Slide the battery cover off, press and hold "SET" key until the year number
appear and flash on LCD, then the unit enter date and time of system
setting mode.
MON. DATE HOUR
mmHg
3. Press " " or " " button to adjust the number of year.
4. Press "SET" key again to adjust month, date, hour and minute by repeating
step 3 and 4.
5. After completing setup, press "SET" key again to enter to measurement mode.
Note: Please check and re-set Date/Time after replacing of new batteries.
The "SET" button please use a pen to press through the pin hole on
the upper side of battery cover.

HOW TO APPLY THE WRIST CUFF

1. Put off your watch and any jewel from your left hand.
2. Hold your left wrist with your palm facing up, apply the cuff so that the
display of monitor is in easy to view.
-11-
MIN.
SYSTOLIC
mm Hg
DIASTOLIC
mm Hg
PULSE /
min.
3. The cuff's edge should be approximately 1/2 to 3/4 inch (1~2cm) from your palm.
1/2" - 3/4 "
(1~2cm)
4. Wrap the cuff snugly around your wrist., the top and bottom edges of the
cuff should be tightened evenly around your wrist and lower arm.
5. When the cuff is positioned correctly, secure it in place by pressing the
pile material firmly against the sewn hook material.
6. Sit in a chair with your feet flat on the floor and place your left arm on a
table with your palm facing upward. The cuff should be at the same level
as your heart.
Note: Your heart is located slightly below your armpit.
7. If the cuff is not at the same level as your heart or if you cannot keep your
arm completely still throughout the reading, use the store box or other
soft object to support your arm.
-12-
Wrist Joint