Replacing The Battery - Pioneer PDV-20 Operating Instructions Manual

06 Controls & Displays

Replacing the battery

1 Pull out the battery holder as
shown below.
Pinch B inward while pulling the battery
holder out from A.
2 Remove the old battery, then
insert the new battery into the
battery holder.
Make sure that the ª side is facing
upwards.
Lithium battery (CR2025)
3 Fit the battery holder back into
place.
62
En
B
A
CR2025
Note:
To prevent leakage of fluid from the
lithium battery, remove the battery when
not using the remote control unit for long
periods of time (one month or more). If
the fluid should leak, carefully wipe it from
the battery case, then insert a new lithium
battery.
Warning (lithium battery)
• Keep out of the reach of children.
• Contact a physician immediately if a
battery should be swallowed.
• Do not take apart, dispose of in flames,
charge, heat, solder or short-circuit.
• Remove the battery if the equipment
isn't going to be used for a month or
more.
Caution!
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
Discard used batteries according to the
manufacturer's instructions.
When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction's rules
that apply in your country or area.