1.01 2014-08-07 Changed default values 1.06 2015-10-19 FMD10-BLE changes 20.62.00-000 < Glossary > Admin, Administrator - As a user who can enter into the terminal menu mode, he can register/modify/delete terminal users and change the operating environment by changing settings.
- If the above cautions are ignored, it may result in property loss or human injury. ※ Under no circumstances will Union Community be responsible for accidents or damages caused by inappropriate use of the product caused by not referring to the user manual.
FMD10 User Guide 1.3. Device description 3 Color LED (Red, Green, Blue) Fingerprint Sensor Capacitive Touch Bell Button Card input area 1.4. LED operation Light off : Normal ● Failure Light on : When authentication is failed Light on: Card or Fingerprint successful authentication. ●...
FMD10 User Guide 1.5. Door Bell Key Operation When pressed beep sound is emitted and the bell output will Normal Operation activate ( Door Bell Operation) 1) Apply Power Initialize Parameters 2) Within 1 second press and hold the bell key for 2 seconds When registering the device with the mobile application press BLE Register Mode and hold the Door Bell Key for 5 seconds.
Page 8
FMD10 User Guide Cautions about fingerprint condition Depending on the user’s fingerprint condition, some fingerprints may not be used or may cause an inconvenience. If the fingerprint is damaged or very unclear, then it cannot be recognized. Please use a password instead in this case. ...
FMD10 User Guide 2. Introduction 2.1. Description FMD10 is a flush mount access control device. It can be used in small/medium business applications or residential access control. FMD10 will provide access into a secured area using a registered fingerprint or card. A door bell feature is available for connecting the FMD10 to a door phone or door bell for visitors.
FMD10 User Guide 2.2. Configuration 2.2.1. Standalone Configuration B-UNIS ● FMD10 Please see the B-UNIS SmartApp User Guide for setup and connection information Establish Bluetooth connection to B-UNIS smartphone application - B-UNIS Password: 9999 - Basic setup when released from a factory NOTE: If the B-UNIS Password is lost and you cannot connect to the FMD10 you should factory initialize the device see 1.5.
FMD10 User Guide 3. Environment Settings 3.1. Parameters Setup parameters are set from the B-UNIS Smartphone application: Terminal/Device Name: 1-30 characters This is the FMD10 name for identifying the device from the Bluetooth Default: FMD10_99999999 Buzzer Sound: ON/OFF This is to control the buzzer output Default: ON Bluetooth Status LED: Enable/Disable If enabled the blue LED will flicker when successfully connected to the B-UNIS application...
Page 12
FMD10 User Guide Card Format:Hexa Reversed, Hexa Normal, Decimal, Decimal_2 When a card is scanned this setting determines the encoding format of the card. Default: Hexa Reversed Wiegand Output: Disabled/26 bit/34 bit If the FMD10 is connected to an external controller using the Wiegand outputs, this is the format of the User ID sent to the external controller using wiegand.
FMD10 User Guide 4. How to use the terminal 4.2. Authentication 4.2.1. Fingerprint authentication When you place your finger on the fingerprint sensor, the light of the sensor will turn on and the buzzer will beep indicating a successful fingerprint scan. You should not remove your finger until the beep is heard.
Page 14
FCC Information This device complies with part 15 of the FCC Results. Operation is subject to the following two conditions : (1) This Device may not cause harmful interface, and (2) This device must accept any interference received, including interference that may cause undesired operation.