Title Name - Pioneer DVR-310 Operating Instructions Manual

Editing
07
Erase
Video mode VR mode
Use this function to erase unwanted titles.
When you erase titles from the Original titles from a VR
mode DVD-RW, the available recording space increases
accordingly. Erasing a title from a Video mode DVD-RW
disc increases the available recording time only if it is the
last title on the disc.
Erasing Play List titles, or titles from a DVD-R, VR mode
or Video mode, will not result in any more free space on
the disc.
1 Highlight the title you want to erase.
2 Select 'Erase' from the command menu panel.
3 Select 'Yes' to confirm or 'No' to cancel, then
press ENTER.
Tip
• You can erase a title quickly by pressing CLEAR when
the title is highlighted. Confirm the edit by pressing
ENTER.

Title Name

Video mode VR mode
You can give titles new names of up to 64 characters long
for VR mode recordings, and up to 40 characters for
Video mode recordings.
1 Highlight the title you want to name (or
rename).
2 Select 'Edit' > 'Title Name' from the command
menu panel.
Disc Navigator (DVD)
4 Titles
Original
DVD
VR Mode
Remain
0h30m
56
En
2titles
1
20:00 FRI 3/12
Play
20:00 Fri 3/12 Pr 4
SP
Title name
Erase
Set Thumbnail 0h30m( 1.0G)
Edit
Erase Section
2
23:00 FRI 3/12
Chapter Edit
23:00 Fri 3/12 Pr 9 SP
Lock
1h00m( 2.0G)
Cancel
Undo
3 Input a name for the selected title.
Input Title Name
12:30 Wed 4/01 Pr 1 SP
• Use the
• A name generated automatically by the recorder will
already be in the name input section of the screen.
Use the
position.
• Select CAPS or small to change to upper or lower-
case, or use the CASE SELECTION buttons (
).
• You can also use the CLEAR button to delete
characters directly (press and hold for two seconds
to delete the whole name). For other remote control
key shortcuts, see Using the remote key shortcuts to
input a name below.
• For discs formatted on a different DVD recorder, you
will see only a limited character set.
4 Highlight 'OK' then press ENTER to enter the
name and return to the main Disc Navigator screen.
• To return to the main Disc Navigator screen without
saving changes to the title name, press RETURN.
Using the remote key shortcuts to input a name
The table below shows the remote control key shortcuts
that you can use to input characters in the name input
screen. Pressing a button repeatedly cycles through the
characters shown.
If you want to enter two characters in succession that are
both on the same button (for example a P and an R),
press to advance the cursor one space manually
between inputting the two characters.
• • •
A B C D E F G H I J K L M . , ? !
CAPS
N O P Q R S T U V W X Y Z ( ) : ;
small
ç
A A A A A A Æ E E E E I I I I
ø
D N O O O O O U U U U Y ß $ %
< >
= _ &
0 1 2 3 4 5 6 7 8 9
+ – / @ [ ¥ ] ˆ ÷ x ± { | } ~ ¡
_
c a <<
£ \ § ¨ © – ¬ – ® ˚
´ µ ¶ ·
¸ o ¿ `
– << 1 1 3
2 3 1 / / /
4 2 4
OK Clear Space
and ENTER to select characters.
buttons to change the cursor
#