Craftsman 315.115970 Operator's Manual page 11

WARNiNG:
Keep a firm grip on the tool with both
hands at all times. Failure to do so could result in
loss of control leading to possible serious injury.
APPLY POLiSh TO SURfACE
See Figure 7.
While holding the buffer/polisher firmly against the
surface, slide the ON/OFF switch to the ON position (to
the left). Always start and stop the polisher on or against
the surface being polished.
Begin by polishing larger flat surfaces, such as the
hood, trunk and roof. Use a broad sweeping motion in a
crisscross pattern. Do not press down on the surface with
the polisher. Let the orbital action of the pad and bonnet
do the work.
Once flat surfaces have been covered, polish curved
surfaces such as car doors and quarter panels. Use small
circular motions.
After applying polish to the entire surface, turn buffer/
polisher off. Wait until the pad stops rotating before lifting
the buffer/polisher from the surface.
For hard to reach areas, such as the underside of
bumpers or side mirrors, apply polish by hand.
OPERATiON
ChANGE TO bUffiNG/POLiShiNG bONNET
See Figure 8.
Remove the battery pack from the buffer/polisher
and remove the application bonnet by loosening the
drawstring and slipping the bonnet off the pad. Replace
with buffing/polishing bonnet, attaching it the same way
as the application bonnet.
Buff the surface in the same order as it was polished,
starting with large flat surfaces and ending with hard-to
reach areas. Use the same motion as for polishing, a
broad sweeping criss-cross pattern on large flat areas and
small circular motions on all other areas. Remember to let
the tool do the work.
WARNiNG:
each use. Make sure they are clean and free from
any loose particles or foreign objects that may be
embedded in the bonnet. Failure to do so could
cause these particles or objects to be thrown
from the tool resulting in possible serious injury or
damage to the work surface.
WARNiNG:
serious personal injury, always operate the tool with
Fig. 7
both hands, keeping one hand on the handle.
11
Check polishing bonnets before
To prevent loss of control and possible
Fig. 8