Operation - Craftsman 315.115970 Operator's Manual

STARTiNG/STOPPiNG ThE bUffER/POLiShER
See Figure 2.
 To start the buffer/polisher, place the power switch in
the ON ( l ) position.
 To stop the buffer/polisher, place the power switch in
the Off ( O ) position.
TO iNSTALL bATTERY PACK
See Figure 3.
Place the power switch in the Off ( O )

 Place the battery pack in the tool.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
tool before beginning operation.
CAUTiON:
When placing battery pack in the tool,
be sure raised rib on battery pack aligns with the slot
in the buffer/polisher and latches into place properly.
Improper installation of the battery pack can cause
damage to internal components.
TO REMOvE bATTERY PACK
See Figure 3.
Place the power switch in the Off ( O )

 Locate latches on side of battery pack and depress
both sides to release battery pack.
ON / OFF
SwITCH
ON (I)
OFF (O)

OPERATiON

position.
position.
PREPARE ThE SURfACE
For best results, the surface should be clean and dry.
Most high-gloss surfaces can be cleaned with a mild
soap and water solution. For removal of stubborn dirt
such as road tar, grease, and bug stains, you can use
a mild ammonia solution such as that used in glass
cleaners. When using bug-removing chemicals, follow
the manufacturer's directions. Before using any cleaning
product, check the label for recommended applications
and follow the directions for use.
Never apply cleaner directly onto surface to be polished.
Apply to a clean cloth then use the cloth to clean the
Fig. 2
surface. Do not use any type of abrasive cleanser as it
may damage or scratch the surface.
9
DEPRESS LATCHES TO
RELEASE BATTERY PACK
WARNiNG:
Battery products are always in
operating condition. Therefore, the switch should
always be locked when not in use or carrying at your
side.
BATTERY
PACK
LATCHES
Fig. 3