Craftsman 315.115970 Operator's Manual page 10

iNSTALLiNG/REMOviNG APPLiCATiON bONNET
See Figure 4.
 Place the power switch in the Off ( O ) position.
 Remove the battery pack from the buffer/polisher.
 Slip application bonnet edges over pad.
 Tie bonnet strings securely.
WARNiNG:
The drawstring must be tucked
securely inside the bonnet before turning the buffer/
polisher on. Failure to do so could result in the
drawstring being caught between the motor housing
and orbiting pad, increasing the risk of serious
personal injury.
 To remove, untie bonnet strings and pull bonnet edges
over and off pad.
PULL APPLICATION
BONNET EDGES OvER PAD TO INSTALL
TIE STRINGS SECURELY
AND TUCK LOOSE ENDS
UNDERNEATH PAD
APPLYiNG POLiSh TO ThE APPLiCATiON bONNET
Most polishes are either in paste or liquid form. Before
using any polish, read and follow all manufacturer's
directions on appropriate applications and proper use.
APPLiCATiON Of PASTE POLiSh
See Figure 5.
Use a putty knife or other flat, blunt object to apply
approximately one rounded teaspoon of paste onto the
bonnet. Evenly spread the paste over the entire surface of
the bonnet.
Do not apply paste directly to the surface being polished.
OPERATiON
APPLiCATiON Of LiQUiD POLiSh
See Figure 6.
Apply a small circle of liquid (about the size of a half-
dollar) around the center of the bonnet, followed by two
more rings, each slightly larger than the previous one.
After the first application, the bonnet will not absorb as
much polish. Apply two rings of polish to the bonnet for
subsequent applications, using half of the initial quantity.
Fig. 4
10
WAX
WAX
Fig. 5
Fig. 6