Stopping Playback And Switching; Power Off - Pioneer DV-K302CD Operating Instructions Manual

Stopping Playback and
Switching Power Off
– DVD/Super VCD/Video CD/CD
4
5
1
2
2
3
1
4
5
2 3
Resuming playback from where
you stopped
1
Resume play is possible only in Normal mode.
With this player, it is possible to resume play of a DVD
or Video CD when play has been stopped.
Press STOP 7 once to enable play to resume
from a point shortly before the DVD/Video CD was
stopped when PLAY 3 is pressed again.
• To begin disc playback from the beginning, press
STOP 7 twice to turn off resume playback, and then
start playback again.
• When STOP 7 is pressed, "RESUME" appears in the
display for as long as resume playback is possible.If
the function is canceled, "RESUME" disappears and
the disc format appears in the display.
Note
• Resume play is only possible when the disc is loaded and
STOP 7 has not be pressed twice in succession ("RESUME"
appears in the display). If you want to continue viewing a DVD
at a later time or date, it is recommended to use the Last
Memory function described on page 53.
• Resume play is not possible in Karaoke mode.
• If the player is switched to Karaoke mode after resume play is
set in Normal mode, resume play is canceled.
• Resume play is cancelled if the PLAYBACK CONTROL is
turned ON/OFF while resume play is set.
• Resume play is not possible with Super VCD and CDs.
• For some discs, playback may not start from the position at
which it was stopped.
Press STOP 7 (7 on the front panel).
Playback stops.
Press OPEN/CLOSE 0.
The disc tray comes out.
The tray rotates and the disc that was playing is
located towards the front on the left side of the
table.
Press DISC CHANGE to remove all the discs.
Press on the remote control.
The disc tray goes back in.
[Models having a POWER switch on the main
unit]
Check that the "–OFF–" indication on the
display goes off, then press POWER on the
front panel.
–– DVD/Video CD
29