Video Connections; System Control Connections - Pioneer DV-C302D Operating Instructions Manual

Video Connections

This player features S-video, composite video and
component video output possibilities. Check the
manual supplied with your TV or monitor to
determine the best possible connection for your
system.
In addition to making physical connections to your TV
or monitor, it is also necessary to assign the TV
screen size. You can use the [Setup Navigator] in the
Setup screen General to set whether you are using a
wide screen or standard size TV or monitor (page 21).
Additionally, you can use the [TV Screen] setting in
the Setup screen Video menu (page 33).
S-VIDEO OUT
• Make S-video connections to a TV or monitor with
S-video input to produce a high quality video image.
• Use an S-video cable (not supplied) to connect one
of the S-VIDEO OUT jacks on the player to S-video
input on the TV or monitor.
• When using this jack, be sure to set VIDEO OUT
SELECT to the left position.
DV-C302D
S-VIDEO OUT VIDEO
OUT
SELECT
VIDEO OUT
• Make composite video connections to a standard
TV or monitor with a video input jack.
• Use the supplied video cable to connect one of the
VIDEO OUT jacks on the player to the video input
on the TV or monitor.
• Be sure to match the color of the plug with the
color of the jack (yellow).
• When using this jack, be sure to set VIDEO OUT
SELECT to the left position.
DV-C302D
VIDEO
VIDEO OUT
OUT
SELECT
COMPONENT VIDEO OUT
• Make component video connections to a projection
• Use component video cables or 3 video cords (not
• When making component video connections, make

System Control Connections

S-VIDEO IN
Using a commercially available cord with a mini plug
(3.5 mm dia. with no resistance) to connect this player's
CONTROL IN jack to the CONTROL OUT jack of another
PIONEER component bearing the Î mark, you can
control the player as though it were a component in a
system (system control).
TV or monitor
• If you connect for system control, you cannot operate
• When controlling as a system, be sure to make a
• For details, refer to the operation manuals of the
VIDEO IN
TV or monitor
monitor, projector or TV with component inputs to
produce a higher quality video image.
supplied) to connect the COMPONENT VIDEO OUT
jacks on the player to the component jacks on the
monitor.
sure to set the VIDEO OUT SELECT switch on the
rear panel of the player to the right to assign
component video output.
VIDEO
OUT
SELECT
DV-C302D
Y
COMPONENT
VIDEO OUT
P
B
P
R
the player directly. Point the remote control unit at the
component (AV amplifier, etc.) connected to the
CONTROL OUT jack to operate.
connection to the amplifier using an audio or video
cord, even when using only digital components.
connected components.
DV-C302D
CONTROL
IN
Projection monitor,
projector or TV
COMPONENT
VIDEO IN
Y
P
B
P
R
CONTROL
OUT
Pioneer component
with Î mark.
19