Intended Use; Inserting/Replacing The Battery - Bosch GLL 150 E Operating/Safety Instructions Manual

of tool, taking into account the working
conditions and the work to be performed.
Use of the tool for operations different from
those intended could result in a hazardous
situation.
Service
Have your tool serviced by a qualified repair
person using only identical replacement
parts. This will ensure that the safety of the tool
is maintained.
Develop a periodic maintenance schedule
for tool.
Follow checking recalibration procedures
outlined in this instruction manual.
When cleaning a tool be careful not to
disassemble any portion of the tool since
Inserting/Replacing the Battery
Always replace all batteries
WARNING
!
at the same time. Only
use batteries from one brand and with the
identical capacity.
Remove the batteries from the tool when not
using it for extended periods. When storing
for extended periods, the batteries can corrode
and discharge themselves.
Alkaline batteries are recommended for
the tool.
The numbering of the product features shown
refers to the illustration of the tool on the graphic
page.
1 Exit opening for laser beam
2 On/Off switch
3 Tripod mount 5/8"-11
4 Tripod mount 1/4"-20
5 Latch of battery lid
6 Battery lid
7 Laser warning label
8 Serial number
Intended Use
The tool is intended for determining and checking level.
internal wires may be misplaced or pinched
or may be improperly mounted. Certain
cleaning agents such as gasoline, carbon
tetrachloride, ammonia, etc. may damage
plastic parts. agents such as gasoline, carbon
tetrachloride, ammonia, etc. may damage
plastic parts.
SAVE THESE INSTRUCTIONS.
Preparation
To open the battery compartment 6, slide the
latch 5 in the direction of the arrow and fold the
battery lid up. Insert the batteries.
When inserting, pay attention to the correct
polarity according to the representation on the
inside of the battery lid.
At approximately 6 hours battery life remaining,
the unit will indicate "battery weak" status by
rapidly flashing the laser on and off for 30
seconds. It will then resume normal operation
until complete switch-off. The 30-second
flashing will repeat on initial startup.
Features
9 Laser target plate*
10 Laser receiver (LR 3)
11 Rod clamp
12 Laser viewing glasses*
13 Tripod (BT 152)
14 Leveling rod (GR 8 C)
* The accessories illustrated or described are
not included as standard delivery.
-7-