Table of Contents
Advertisement
Others
09
Problem
Player cannot be restored to
the factory defaults.
Player cannot be controlled
by RS-232C.
The player's power turns off
automatically.
The player's power turns on
automatically.
Player cannot be operated
with remote control.
Black screen is displayed
though no operations are
being performed.
Front panel display does not
turn on.
Buttons on the player's front
panel cannot be operated or
the disc tray does not open.
Input of connected TV and AV
system switches
automatically.
"Processing failed." is
displayed.
Settings you have made have
been cleared.
72
En
Check
Is a disc loaded in the player? Remove the disc from the player before restoring the player to the
Is Auto Power Off set to
On?
Is Display Power Off set to
On?
Is KURO LINK set to On?
Is an AV receiver or amplifier
connected to the CONTROL
IN terminal on the player's
rear panel?
Are you operating the remote
control from a point too far
away from the player?
Are the batteries dead?
Is the RC-232C Key Lock
command set?
Is Screen Saver set to On?
Has the front panel display
been turned off?
Is Front Key Lock set to All
or Tray?
Is KURO LINK set to On?
• Have you disconnected the
power cord while the player's
power was on?
• Has there been a power
failure?
Remedy
factory defaults (page 51).
Check the Advanced Setup Baud Rate setting and the serial
interface specifications (page 56 and 58).
If Auto Power Off is set to On, the player's power turns off
automatically if no operation is performed for over 30 minutes
(page 46).
The player's power may turn off together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player's
power to turn off when the TV's power is turned off, set Display Power
Off to Off (page 44).
The player's power may turn on together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player's
power to turn on when the TV's power is turned on, set KURO LINK to
Off (page 44).
Operate with the remote control of the device connected to the
CONTROL IN terminal.
Operate from within 23 feet (7 m) of the remote control sensor.
Replace the batteries (page 7).
Cancel the Key Lock command. For details, see the communications
interface user's manual.
• The screensaver turns off when the player's front panel or remote
control is operated.
• If you do not want the screensaver to be activated, set Screen Saver
to Off (page 46).
Press FL DIMMER on the remote control to switch the front panel
display's brightness (page 12).
Set Front Key Lock to Off (page 55).
The input of the TV and AV system (AV receiver or amplifier, etc.)
connected to the HDMI OUT terminal may automatically switch to the
player when playback starts on the player or the menu screen (Home
Media Gallery, etc.) is displayed. If you do not want the inputs of the
connected TV and AV system (AV receiver or amplifier, etc.) to switch
automatically, set KURO LINK to Off (page 44).
If the message appears repeatedly, please ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
Always press STANDBY/ON on the player's front panel or
STANDBY/ON on the remote control and check that POWER OFF
has turned off from the player's front panel display before
disconnecting the power cord. Be particularly careful when the power
cord is connected to the AC outlet on another device because the
player turns off in conjunction with the device.
Advertisement
Table of Contents
