Cleaning The Pickup Lens; Problems With Condensation; Moving The System Unit; Power Cord Caution - Pioneer HTD88DVD Operating Instructions Manual

Additional information
Place on an unstable surface, or one that is
not large enough to support all four of the
system unit's feet.

Cleaning the pickup lens

The DVD player's lens should not become dirty
in normal use, but if for some reason it should
malfunction due to dust or dirt, consult your
nearest Pioneer authorized service center.
Although lens cleaners are commercially
available, we do not recommend using them
since some may damage the lens.

Problems with condensation

Condensation may form inside the system unit
if it is brought into a warm room from outside,
or if the temperature of the room rises quickly.
Although the condensation won't damage the
system, it may temporarily impair its
performance. For this reason you should leave
it to adjust to the warmer temperature for
about an hour before switching on and using.

Moving the system unit

If you need to move the main unit, first remove
all discs, then press
front panel to turn the system off. Wait for
Good Bye to disappear from the display, then
unplug the power cord. Never lift or move the
system during playback—discs rotate at a high
speed and may be damaged.
• Unplugging the system before Good Bye
disappears from the display may cause the
system to return to the factory settings.

Power cord caution

Handle the power cord by the plug part. Do not
pull out the plug by tugging the cord, and never
touch the power cord when your hands are
wet, as this could cause a short circuit or
STANDBY/ON on the
electric shock. Do not place the system unit, a
piece of furniture, or other object on the power
cord or pinch the cord in any other way. Never
make a knot in the cord or tie it with other
cords. The power cord should be routed so that
they are not likely to be stepped on. A damaged
power cord can cause a fire or give you an
electric shock. Check the power cord once in a
while. If you find it damaged, ask your nearest
Pioneer authorized service center or your
dealer for a replacement.

Connecting external antennas

External AM antenna
Use 5 to 6 meters of vinyl-insulated wire and set
up either indoors or outdoors. Leave the AM
loop antenna connected.
Outdoor antenna
Indoor
antenna
(vinyl-coated
wire)
5 m to 6 m
External FM antenna
Use 75 Ω coaxial cable to hook up an external
FM antenna.
75 Ω coaxial cable
ANTENNA
AM LOOP
ANTENNA
FM
UNBAL
75
12
ANTENNA
AM LOOP
ANTENNA
FM
UNBAL
75
71
En