Table of Contents
Advertisement
VIII. Factory Default
If you forget your password, please follow the steps to revert back to default
value.
• Remove the power and Ethernet cable.
• Take an electronic wire, plug one side of the wire into "Default" and the
other side into "GND" on the terminal block as the picture below.
•Connect the power to the camera again. It takes around 30 seconds to boot
the camera.
• Remove the wire and plug in the Ethernet cable after the camera
finishes booting.
• Re-login the camera using the default IP (http://192.168.1.200), and user name
(admin), password (admin).
69/74
Advertisement
Table of Contents
