Table of Contents
Advertisement
ZXC10 CBTS O1 Hardware Installation Manual
6. Shell tightening
Put a piece of cloth between wrench and shell, use wrench to tighten
shell and tail connecting parts. Figure 80 shows this process. Ensure
that torque lies in the range of 98 Nm to 120 Nm and pin is at one
level inside the cable.
F
I G U R E
GPS Connector Installation Check
After GPS cable installation check following:
Pin should be at same level inside the shell.
Connector strength must be more than 60 N.
Insulation resistance between pin and shell must be more than 5000 M
ohms.
Check resistance between feeder cable pins and conductors head.
Check resistance between conductors head.
92
Confidential and Proprietary Information of ZTE CORPORATION
8 0 - S
T
H E L L
I G H T E N I N G
Advertisement
Table of Contents
