Power Subrack - Zte ZXC10 CBTS O1 Installation Manual

Power Subrack

Power subrack is already installed and is debugged before delivery.
Following section describes method for rectifier module installation in
subrack during maintenance.
Install power subrack with a maximum of four rectifier modules, in 3+1
backup mode and accept hot plugging.
1. Dismantle
i. Loosen both side screws on module handle and put handle into
OPEN state.
ii. Hold handle and take out module, Figure 18 shows this process.
F 1 8 - T
I G U R E A K I N G O U T
1. Screw
2. Installation
Loosen both side screws on module handle and put handle into OPEN
state, Figure 19 shows this process.
F 1 9 - R
I G U R E E C T I F I E R
1. Handle
R M
E C T I F I E R O D U L E
2. Handle
M – H O P E N S
O D U L E A N D L E I N
2. Screw
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 - Cabinet Installation
T A T E
41