Connector Preparation Procedure - Zte ZXC10 CBTS O1 Installation Manual

Figure 69 shows NJ-9 GPS connector parts.
F 6 9 - N J - 9 G P S C
I G U R E
1. Shell
3. Air proof washer 1
5. Air proof washer 3
7. Insulating washer
9. Inner conductor pin

Connector Preparation Procedure

Take following steps to prepare GPS connector:
1. Stripping GPS cable shell
Use sharp knife to strip GPS cable outer covers about 0.41 inch ±
0.009 inch (10.5 mm ±0.25 mm). Avoid damaging inner copper wires.
Figure 70 shows stripped cable.
F 7 0 - S
I G U R E T R I P P I N G
Chapter 6 - GPS Antenna Feeder System Installation
P
O N N E C T O R A R T S
2. Tail connector
4. Air proof washer 2
6. Insulating washer
8. Insulation plate
G P S C
A B L E
±
10.5 mm 0.25 mm
Confidential and Proprietary Information of ZTE CORPORATION 87