Remote Controller Wiring - Toshiba RAV-SP1104AT8-E Service Manual

10-3. Remote Controller Wiring

• Strip off approx. 9 mm the wire to be connected.
• For single system, use non polarity, 2 core wire is
used for wiring of the remote controller.
(0.5 mm² to 2.0 mm² wires)
• For the synchronous twin, triple system, use
2-conre shield wire (Vinyl cord for microphone 0.5
to 2.0 mm²) to conform to the EMC standard.
Single system
Remote controller
Remote controller wiring
Indoor side
Indoor/Outdoor
connecting wires
Outdoor side
Simultaneous triple system (SP160 only)
Remote controller
Remote controller
wiring
Indoor side
Indoor/Outdoor
connecting wires
Outdoor side
AMP Air Conditioning
A B
1 2 3
1 2 3
N
L1 L2 L3
380-415 V 3N~, 50Hz
380 V 3N~, 60Hz
Remote controller
inter-unit wiring
A B
Indoor side
1 2 3
1 2 3
N
L1 L2 L3
380-415 V 3N~, 50Hz
380 V 3N~, 60Hz
Wiring diagram
Terminal block for remote controller
wiring of indoor unit
A
B
Remote controller wire
(Procured locally)
∗ For details of wiring/installation of the remote
controller, refer to the Installation Manual enclosed
with the remote controller.
Simultaneous twin system
Remote controller
Remote controller
wiring
Indoor side
Indoor/Outdoor
connecting wires
Outdoor side
380-415 V 3N~, 50Hz
Remote controller
inter-unit wiring
A B
Indoor side
1 2 3
Indoor power Indoor power
inter-unit wiring inter-unit wiring
Triple
– 95 –
www.ampair.co.uk | sales@ampair.co.uk
Terminal block
Remote controller
A
unit
B
Remote controller
inter-unit wiring
A B
Indoor side
1 2 3
Indoor power
1 2 3
inter-unit wiring
N
L1 L2 L3
380 V 3N~, 60Hz
A B
1 2 3
A B
1 2 3