Wiring And Setting Of Remote Controller Control - Toshiba RAV-GM901KRTP Series Service Manual

Table of Contents

Advertisement

10-5. Wiring and Setting of Remote Controller Control

2-remote controller control
(Controlled by 2 remote controllers)
This control is to operate 1 or multiple indoor units
are operated by 2 remote controllers.
(Max. 2 remote controllers are connectable.)
• When connected 2 remote controllers
operate an indoor unit
Remote controller switch
(Master)
Sold
separately
A
B
Remote controller wires
(Procured locally)
Terminal block for
remote controller wires
A
B
Indoor unit
1
2
3
1
2
3
Outdoor unit
(Setup method)
One or multiple indoor units are controlled by
2 remote controllers.
(Max. 2 remote controllers are connectable.)
<Wired remote controller>
How to set wired remote controller
as sub remote controller
Change DIP switch inside of the rear side of the
remote controller switch from remote controller
master to sub.
Remote controller (Inside of the rear side)
1 2
[Operation]
1. The operation contents can be changed by
Last-push-priority.
2. Use a timer on either Master remote controller
or Sub remote controller.
Remote controller switch
(Sub)
Sold
separately
A
B
1 2
Sub remote
controller
Master remote
controller
1 2
DIP switch
- 70 -
<Wireless remote controller A-B selection>
Using 2 wireless remote controllers for the respective
air conditioners, when the 2 air conditioners are
closely installed.
Wireless remote controller B setup
1. Push
[TEMPORART] button on the indoor unit
to turn the air conditioner ON.
2. Point the wireless remote controller at the indoor
unit.
3. Push and hold
button on the wireless remote
CHK l
controller by the tip of the pencil.
"00" will be shown on the display.
MODE
l
4. Push
during pushing
"B" will be shown on the display and "00" will be
disappear and the air conditioner will turn OFF.
The wireless remote controller B is memorized.
"B" Display
"00" Display
NOTE
• Repeat above step to reset wireless remote
controller to be A.
• The wireless remote controllers do not display "A".
• The factory default of the wireless remote
controllers is "A".
.
CHK l
PRESET
FAN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rav-gm901krtp-eRav-gm901krtp-tr

Table of Contents