Download Print this page

Hotpoint RGB744GEN Use, Care & Installation Manual page 15

Advertisement

@+~#ftercleaningis complete, t he
'-@
door will stay lockeduntil the oven
cools and the CLEANING light
goesoff. This takes about 30
minutes.
step
1:
When CLEmG
light is off, slide
the latch handle to the left as far as
it will go and open the door.
step
2:
Push and turn OVEN'TEIMPknob
to OFF.
NmE: If
YOU
wish to start and
stop cleaning at a later time than
shown on clock, push in and turn
DELAY STARTdial to time you
wish to start. Add the hours needed
for cleaning to this "stirt" time,
then push in and turn S~P TIME
dial to this desired stop time. Oven
will automatically turn on and off
at the set times.
Queaiom
a~ld
Amwers
Q.
why
won't m y oven clean
timedstely
even
though
I
set
alf the
time
and clean linobs
correctly?
A. Check
to be sure the DELAY
STARTdial is set to the same time
as the range clock. Also check to
be sure the latch handle is movedto
the right.
Q. Mthe ovenClwk k not WoR'tig,
can I stil~self-elmn my oven?
A. No. The AutomaticOven Timer
uses the range clock to help start
and stop the self-cleancycle.
Q. can I use Comercial oven
C!eanerson any part of my
self-cleating oven?
A. No cleaners or coatings should
be used around any part of this
oven. If you do use them and do not
thoroughly rinse the oven with
water, wiping it absolutelyclean
afterwards, the residue can scar the
oven surface and damage rneti
parts the next time the oven is
automatically cleaned.
Q. can I 'clean
the woven
Gasket
around the oven door?
A. No,
this gasket is essential for
a good oven seal, and care must be
taken not to rub, damage or move
this gasket.
Q. After having just used the
oven?the CLEANING light came
on and I could not move
thelatch
handIe* why?
A.
After several continuous high-
temperature bakings or broilings,
the CLEANING light may come
on. The oven door can't be latched
for self-cleaning while the
CLEANING light is on. If this
happens, let the oven cool until the
CLEANING light goes off. Then
the oven door can be Iatched for
se~ f-cleaning.
Q. l~ihat Should I do if excessive
Snlol<ingfoefcursduring cleaning?
A. This is c~dsed by excessive soil,
a~ldyou silould switch tile OVEN
~~. open
TE?iiP knob to 0..
wind~ws 'tor'idroom.ef Smol<e.
Allowthe ovento cool for at least
one hour beforeopeningthe door.
Wipeup the excesssoil and reset
the clean cycle.
Q. k the "craeMillg" sound I
hear during Cleaningnormal?
A. Yes.This is the metal heating
and coolingduring both the
cookingand cleaningfunctions.
Q. Should there be any odor
during the 'cleaning?
A. Yes,
there maybe a slightodor
duringthe firstfewcleanings.Failure
to wipe out excessivesoil might
dso cause an odor when cleaning.
Q.
What
causes the
hair-like
linesOnthe
enamel surface of my
oven?
A. This is a normal condition
resulting from heating and cooling
during cleaning. They do not affect
how your oven performs.
Q. why do I have ash left in my
oven after cleating?
A. Some types of soil will leave
a deposit which is ash. It can be
removed with a damp sponge or
cloth.
Q. lvy oven shelves do not slide
easily. what is the matter?
A.
After many cleanings, oven
shelves may become so clean they
do not slide easily. To make shelves
slide more easily,-aftereach self-
clean cycle, dampen fingers with a
small amount of cooking oil and
rub lightly over edges of shelf
that
contactshelfsupports.
Q. My ovenshelveshave becoERe
gray after the self-clean
cycle. Is
this norma~?
A. Yes.During the self-clem cycle,
the shelves may lose some luster
and discolor to a deep gray.
Q. cm I COoli f ood on
the Cooldo}l
vdhilethe 0ve]2 is self-cleaning?
A. Yes.
While the oven is self-
cleaning, you can use the cool<top
just as you nol:mallydo. I-Iowever,
be carefil wi~ensanding in front of
the range—the oven becomes veyy
hot 'whileself-cleaning.

Advertisement

loading

This manual is also suitable for:

Rgb745gen