Setting The Unit; Gain Control; Power Indicator; Input Select Switch - Pioneer GM-6200F Owner's Manual

Setting the Unit

Gain Control

Adjusting the gain controls A and B
will help match the output of the car
stereo to the Pioneer amplifier.
Normally, set the gain controls to the
NORMAL position. If the output is
low, even when the volume of the car
stereo is turned up, turn these controls
clockwise. If there is distortion when
the volume of the car stereo is turned
up, turn these controls counter-clock-
wise.
• If you only use one input plug, set the
gain controls for speaker outputs A and
B to the same position.
• When using with an RCA equipped car
stereo (standard output of 500 mV), set
to the NORMAL position. When using
with an RCA equipped Pioneer car
stereo with max. output of 4 V or more,
adjust level to match the car stereo out-
put level.

Input Select Switch

For two-channel input, slide
this switch to the left. For
four-channel input, slide this
switch to the right.
LPF (Low-Pass Filter)/HPF (High-Pass Filter) Select Switch
Set the LPF/HPF select switch as follows according to the type of speaker that is connected
to the speaker output connector and the car stereo system:
LPF/HPF Select
Switch
LPF (Left)
OFF (Center)
HPF (Right)

Power Indicator

Audio frequency range
to be output
— 80 Hz
Full range
80 Hz —
<ENGLISH>
BFC (Beat Frequency
Control) Switch
If you hear a beat while
listening to an AM broadcast
with your car stereo, change
the BFC switch using a small
standard tip screwdriver.
The power indicator
lights when the power is
switched on.
Speaker Remarks
Type
Subwoofer Connect a subwoofer.
Full range
Full range Use if you want to cut the
very low frequency range
because it is not necessary
for the speakers you are
using.
S P E
CH A
BR A K
ID GE
E R
D
O N
P U
T
BR
ID GE
D
CH B