Ns8 Rear Panel - Omron NS12 Quick Start Manual

OMRON

2.2 NS8 Rear Panel

Power Input Terminal Block Cover
Covers the power input terminal block.
FG Terminal
Used to prevent malfunctions
due to noise interference.
Main Circuit DC Input Terminal
Used to connect the power
supply .
USB Host Connector
Used to connect to printers.
It is a USB Type A
connector.
Page 8
Expansion Interface Connector
Used to mount the Video Input Unit or the
Controller Link Interface Unit.
Serial Port B Connector
Used to connect the host, NS-Designer, and
Bar Code Reader. Uses an RS-232C 9-pin
connector.
Ethernet Connector
USB Slave Connector
Used to connect the
This is a USB Type B
Ethernet cable. Uses a
connector. (It cannot be
10Base/100BASE-T 8-pin
used with NS Ver. 5.0
RJ45 modular plug.
systems.)
NS Series Quick Start Manual
Memory Card Connector
Used to connect the memory car d
for storing and transmitting
screen data, log data, and s ystem
programs.
DIP Switch
Used to set the settings for
transmitting data using the
Memory Card.
Reset Switch
Used to initialize the PT.
The status of screen data,
other registered data, and
memory switches, however,
will not change.
Battery Cover
The battery is installed
underneath the cover.
Serial Port A Connector
Used to connect the host, NS-Designer, and
Bar Code Reader. Uses an RS-232C 9-pin
connector.