Advertisement
GETTING READY TO CLEAN UPHOLSTERY,
MATTRESSES, STAIRS, VEHICLE INTERIORS AND
FRESH STAINS, USING THE HAND TOOL
SETTING UP/GETTING READY TO
CLEAN USING THE HAND TOOL
1. Position the FOLD DOWN HANDLE as far
back as possible to allow easy access to
the TOOL SPRAY CONNECTION.
2. Fill the CLEAN WATER TANK:
a. Remove the CLEAN WATER TANK by
gripping the tank HANDLE and lifting
straight up. (Fig. 20)
(Fig 20)
b. Loosen the TANK LID by turning
anti-clockwise and remove from the
machine, set aside.
c. Fill the tank with hand hot tap water
to the "CLEAN WATER FILL LINE". Use
luke warm water on wool/wool mix
fabrics.
DO NOT USE BOILED OR MICROWAVED
WATER IN TANK.
d. The TANK LID is also the "Carpet
detergent/fabric cleaner" measure.
Fill the lid with Rug Doctor Oxy Fabric
Cleaner to the 120ml mark. (Fig. 21)
DO NOT USE BOILED OR MICROWAVED WATER IN TANK. Doing so could
result in scalding or burns and damage to the machine. ALWAYS CHECK FOR
COLOURFASTNESS. Do not overwet the carpet. Use luke warm water on wool
and wool blend carpets. DO NOT USE on natural fibre, silk or pure wool oriental
rugs, hand loomed wool rugs, braided rugs, sisal, sea grass matting or jute
carpets, silk, haitian cotton, brushed corduroy, leather, non colourfast fabrics,
berber, Flotex, Ryalux carpets, wood effect laminate flooring. Doing so could
damage material and void warranty on machine. Do not walk on wet carpet.
10
01903 235558
rugdoctor.co.uk
(Fig 21)
e. Pour the fabric cleaning solution into
the CLEAN WATER TANK and replace
the lid. Turn clockwise to tighten.
f. Place the CLEAN WATER TANK back in
the machine, making sure it is secure.
3. Rotate the CABLE WRAP HOOK on the
handle to release the mains power cable.
Unwrap the MAINS POWER CABLE and
plug in to a mains socket. Making sure the
POWER SWITCH is in the "OFF" (middle)
position. (Fig. 22)
(Fig 22)
HOW TO CLEAN / FEATURES
CLEANING WITH THE HAND TOOL
1. Unwrap the HAND TOOL from the CADDY.
(Fig. 23)
(Fig 23)
2. Open the TOOL VACUUM CONNECTION
by pulling open the black rubber flap.
(Fig. 24)
(Fig 24)
3. Insert the HAND TOOL vacuum connection
horizontally into the WASTE WATER PORT
on the front of the WASTE WATER TANK
by lining up the "O" icons on the tank and
the TOOL. If there is any problem fitting
this in it is only because it is not being
pushed in at the correct angle. (Fig. 25)
(Fig 25)
4. Lock the TOOL into place by rotating to
the right, the
icon will be straight up.
(Fig. 26)
(Fig 26)
5. With the machine handle tilted as far back
as possible to allow easy access, connect
the red braided hose connector to the
"TOOL SPRAY CONNECTION" located on
the side of the top of the machine. The
O-ring on new machines can be a tight fit
so you may need to wiggle it from side-
to-side while pushing firmly down in order
to ease the coupling into the connection.
Lock the tool into place by rotating
clockwise. After a few uses the connection
will ease up. (Fig. 27)
1
2
3
(Fig 27)
6. You're now ready to deep clean your
upholstery, mattresses, stairs, fabric
vehicle interiors and carpet spots and
stains. Turn the machine on by pressing
the POWER SWITCH down toward the
"TOOL" setting. (Fig. 28)
(Fig 28)
rugdoctor.co.uk
01903 235558
11
Advertisement
