Advertisement
HOW TO CLEAN / FEATURES (CONT.)
EMPTYING THE WASTE WATER
TANK
1. Empty the WASTE WATER TANK before
the dirty water reaches the "Full Line"
(Fig. 11).
(Fig 11)
2. Turn off the machine by pressing the
POWER SWITCH into the middle setting.
3. Remove the WASTE WATER TANK from
the machine by gripping the tank HANDLE
and lifting straight up. (Fig. 12)
(Fig 12)
4. Unscrew the WIDE OPENING LID and pour
out the dirty water. DO NOT open the
black rubber tool vacuum connection flap
(Fig. 13). Dirty water should be poured
into a toilet or outside drain, do not pour
into sink or bathtub/shower.
(Fig 13)
8
01903 235558
rugdoctor.co.uk
5. Rinse the inside of the WASTE WATER
TANK and replace the WIDE OPENING
LID, firmly tighten the lid.
6. Place the tank back on the machine by
setting is straight down on the base until it
is secure. (Fig. 14)
(Fig 14)
REFILLING THE CLEAN WATER
TANK
1. When the unit no longer sprays water out
of the sides of the machine, check the
CLEAN WATER TANK to see if it's empty.
2. If the CLEAN WATER TANK is empty, turn
off the machine by pressing the POWER
SWITCH into the middle setting.
3. Remove the CLEAN WATER TANK by
gripping the TANK HANDLE and lifting
straight up. (Fig. 15)
(Fig 15)
4. Loosen the TANK LID by turning anti-
clockwise and remove from the machine,
set aside (Fig. 16). Fill the tank with hand
hot tap water to the "CLEAN WATER FILL
LINE". Use luke warm water on wool/
wool mix carpets. DO NOT BOIL OR
MICROWAVE WATER.
(Fig 16)
5. The TANK LID is also the "Carpet
detergent/fabric cleaner" measure. (Fig.
17). For normally soiled carpets fill up to
the 60ml mark. For heavily soiled carpets
fill up to the 120ml mark
(Fig 17)
6. Pour the cleaning solution into the CLEAN
WATER TANK and replace the lid. Turn
clockwise to tighten.
7. Place the CLEAN WATER TANK back in
the machine, making sure it is secure.
CLEANING UP/STORAGE AFTER
USE
After you've used your RUG DOCTOR DEEP
CARPET CLEANER follow these easy steps
for quick clean-up and storage for your
machine.
1. Turn the machine off by pressing the
POWER SWITCH to the middle "OFF"
setting.
2. Turn off the mains socket switch. Unplug
the MAINS POWER CABLE from the mains
socket and wrap it around the ROTATING
CABLE HOOKS and secure with the cable
tidy clip.
3. Empty the CLEAN WATER TANK (if
necessary), rinse, dry and replace on the
machine.
4. Empty the WASTE WATER TANK then
rinse, clean and dry before placing back
on the machine.
The WIDE OPENING LID is designed to
allow your hand to get inside in order to
thoroughly clean, rinse and dry so you are
storing a fresh and clean tank. (Fig. 18)
(Fig 18)
5. Wheel the machine to a cupboard or
other indoor storage place. Use the
HANDLE RELEASE lever to fold down
the HANDLE for convenient and compact
storage. (Fig. 19). Tip: Let the machine
brushes dry before putting the machine
away.
(Fig 19)
rugdoctor.co.uk
01903 235558
9
Advertisement
