Advertisement
GETTING READY TO CLEAN CARPETS
Your RUG DOCTOR DEEP CARPET CLEANER is ready to start cleaning right out of the box. No
assembly required! Follow these simple instructions to start cleaning.
1. Using the HANDLE RELEASE raise the
handle to a comfortable position: It will
click into the nearest locking position.
You will need to keep the front nozzle in
contact with the carpet at all times when
pulling machine backwards. (Fig. 6).
(Fig 6)
2. Fill the CLEAN WATER TANK:
a. Remove the CLEAN WATER TANK by
gripping the tank HANDLE and lifting
straight up. (Fig. 7)
(Fig 7)
b. Loosen the TANK LID by turning
anti-clockwise and remove from the
machine, set aside.
c. Fill the tank with hand hot tap water
to the "CLEAN WATER FILL LINE". Use
luke warm water only on wool / wool
mix carpets.
DO NOT USE BOILED OR MICROWAVED
WATER IN TANK.
DO NOT USE BOILED OR MICROWAVED WATER IN TANK. Doing so could
result in scalding or burns and damage to the machine. Not recommended for
use on wool, jute, sisal carpets and rugs. Doing so could damage material and
void guarantee on machine. Do not walk on wet carpet.
6
01903 235558
rugdoctor.co.uk
d. The TANK LID is also the "Carpet
Detergent/Fabric Cleaner" measure.
Fill the lid with Rug Doctor cleaning
solution to the desired level. For
normally soiled carpets fill up to the
60ml mark. For heavily soiled carpets
fill up to the 120ml mark (Fig. 8)
(Fig 8)
e. Pour the cleaning solution into the
CLEAN WATER TANK and replace the
lid. Turn clockwise to tighten.
f. Place the CLEAN WATER TANK back in
the machine, making sure it is secure.
g. Check the black POWER SWITCH in the
handle to make sure it is in the middle
"off" position. This switch is also the
cleaning mode selector.
h. The MAINS POWER CABLE will come
wrapped and tied. Release the MAINS
POWER CABLE and plug in to a mains
socket.
i. NOTE: The machine was designed with
convenient rotating CABLE WRAP
HOOKS to store the CABLE on board
the machine. The CABLE WRAP HOOKS
on the handle rotate to easily release
the mains power cable.
HOW TO CLEAN / FEATURES
You're now ready to deep clean your carpets and rugs. Your RUG DOCTOR DEEP CARPET
CLEANER has innovative features: DUAL CROSS ACTION BRUSHES to clean deep down in
carpet and SUPER BOOST SPRAY which allows you to customise your clean for high-traffic and
heavily soiled areas.
DUAL CROSS ACTION BRUSHES
Your Rug Doctor Deep Carpet Cleaner
uses DUAL CROSS ACTION BRUSHES. Two
brushes under the machine deep clean all
sides of the carpet fibres. This innovative
technology deep cleans each carpet fibre,
then grooms and polishes the carpet to
restore bounce and provide a plush looking
result – all in one cleaning pass.
1. With the machine MAINS POWER CABLE
plugged into a mains socket and the
socket turned on, turn the machine ON
by pressing the POWER SWITCH down
toward the "CARPET" setting.
2. The DUAL CROSS ACTION BRUSHES
are activated by the red "DEEP CLEAN"
button on the top of the handle. (Fig. 9)
(Fig 9)
a. The Vibrating oscillating brush scrubs all
sides of the carpet pile, deep cleaning
each fibre from the base of the carpet
up.
b. The Roller Brush grooms and polishes
the carpet, restoring it's bounce and
leaving it looking clean and plush. Note:
Your Rug Doctor Deep Carpet Cleaner
also features Side Brushes for edge
cleaning along carpets.
SUPER BOOST CLEANING
Not every carpet needs the same level of
deep clean, some need a SUPER BOOST.
Use the "SUPER BOOST SPRAY" setting on
the machine for an extra "boost" in cleaning
heavily soiled and high-traffic areas.
1. Use the SUPER BOOST SPRAY selector
to choose your desired level of deep
cleaning. (Fig. 10)
(Fig10)
a. SUPER BOOST "OFF": For lightly soiled
carpets set the SUPER BOOST SPRAY
on the machine to "OFF". The machine
will only then spray cleaning solution
onto the carpet under the machine. As
you pull the machine backwards, you'll
see the dirty solution from the carpet
being suctioned into the machine.
b. SUPER BOOST "ON": For moderately/
heavily soiled or high-traffic carpets set
the SUPER BOOST SPRAY selector on
the machine to "ON". The machine will
spray additional cleaning solution from
the "SUPER BOOST SPRAY" nozzle in
advance of the machine clean.
2. Position the machine on carpet and push
the POWER SWITCH down toward the
"CARPET" setting.
3. Press the "DEEP CLEAN" button on
the top of the handle while pulling the
machine slowly and steadily backward
in a straight line. You will see the SUPER
BOOST SPRAY lifting the dirt in advance
of the machine clean. (Fig. 9)
4. Release the "DEEP CLEAN" button
approximately 2 steps before ending each
pass to stop cleaning solution as there will
be no vacuuming for the very last part of
the run. Tilt the machine back and push it
forward to the beginning of the next run
to start a new backward cleaning pass.
5. To clean the area where you stopped the
run, position the machine at right angles
to the cleaning paths you have already
completed and repeat the above.
rugdoctor.co.uk
01903 235558
7
Advertisement
