Page 1
Operating Instructions 2-PORT HDBaseT SPLITTER 2-PORT HDBaseT SPLITTER Features Features •Incorporates HD Base-T technology •Distributes 1 HDMI source to 2 HDMI Displays simultaneously. •Incorporates HD Base-T technology •Full HD support: 1080p@60Hz@48 b/pixels, support 3D and 4Kx2K •Distributes 1 HDMI source to 2 HDMI Displays simultaneously. •Extends HDMI and IR up to 328 feet (100 meters) using one CAT5e (or better) cable •Full HD support: 1080p@60Hz@48 b/pixels, support 3D and 4Kx2K •With Infrared control signal passing through function.
Page 2
TABLE OF CONTENTS Operating Instructions Package Contents Dimensional drawing TABLE OF CONTENTS Panel Descriptions Package Contents Connecting and Operating Dimensional drawing Typical Application Maintenance Panel Descriptions Product Service Connecting and Operating Warranty Typical Application Packing contents Maintenance 1) Main Unit: 1x2 HDBaseT Splitter Product Service 2) Power supply DC 5V 3A Warranty...
Page 3
Operating Instructions -5 to +35 C(+23 to +95 F) 5 to 90%RH (No Condensation) 300MHz/9Gbps Up to 1080p@60Hz@48 b/pixels, support 3D ,4K HDMI receptacle. RJ45 Power connector terminal Power DC receptacle IR Blaster D-Type 9pin plug 1080P 328FT/100m over single CAT5E/6 cable 110-240V/ 5VDC 3A power supply 10Watts Cold-Rolled (Cold Rolled) Steel...
Page 4
Operating Instructions Front Panel Power ON/OFF Reset key Status indicator lamp:The LED will illuminate when the HDMI equipment is connected. Power indicator lamp:The LED will illuminate when the power is on. Rear Panel Ethernet port Output1 port ( Ethernet,RS232 &IR pass-though) Output2 port ( IR pass-though) HDMI input port Power input port...
Page 5
Operating Instructions 7) To get on the ethernet,pls connect as below steps: 1.Connect ethernet cable into ethernet port on HDBaseT splitter. 2.Connect ethernet cable with TV and ethernet extender receiver Note:1.The ethernet function is designed for ethernet compatible receiver units only. Router 2.Only output1 with ethernet function.
Page 6
Operating Instructions 7) Copy EDID function Copy the EDID of the sink which connected the OUTPUT1,it is suggested to put lowest or Router For example: One SDTV(480p) ,one HDTV(1080p), in order to make the 2 TV work, you need to put the Internet SDTV is connected to the output 1 .
Need help?
Do you have a question about the SX-SPH2-100 and is the answer not in the manual?
Questions and answers