Acquiring/Cataloging Ipod Music Information - Pioneer AVIC F500BT Operation Manual

Customizing preferences
! Built-in — Outputs the sound from the
built-in speaker only.
! Preout — Outputs the sound from the
audio output terminal only.
p This product's audio output terminal is the
mini-plug at the cradle's cable end.
p When the navigation system is combined
with ND-G500 (sold separately), select "Pre-
out".
p When the headphone is connected, no
sounds are output from both the built-in
speaker and audio output terminal.
Acquiring/Cataloging iPod
music information
If you always set the language other than "Eng-
lish" on "Program language:", this setting is
unnecessary.
Unless [VR Catalog Mode] is turned off, this
navigation system tries to acquire the informa-
tion needed to operate iPod with voice com-
mands. It may take a short period of time to
transfer the information. Change the setting
according to your usage.
The navigation system starts acquiring/catalo-
ging music information (1) when the iPod is
connected or when the system boots up while
the iPod is connected and (2) when iPod is the
selected and displayed AV Source, unless [VR
Catalog Mode] is turned off.
p If you do not use iPod, this setting is un-
necessary.
p During transfer, iPod operations (such as
[Shuffle], [Menu], or [Video]) are not
available.
p Once the cataloging is completed, you can
deactivate [VR Catalog Mode] until you
update the content/data on iPod. If you up-
date the iPod data, activate [VR Catalog
Mode] again to transfer the music informa-
tion and synchronize the music information
for voice commands with the data on iPod.
p After you select "Off" in [VR Catalog
Mode], the system doesn't catalog the
data on the iPod. In such case, the pre-
viously cataloged data are available as
voice commands.
p Once you start the cataloging process, only
a few basic voice commands can be used
for iPod until the process has completely
finished.
p If unreadable characters are included in
the data on your iPod, names or types may
not be available as voice commands.
Important Notice regarding Voice
Control for iPods
Voice Control for iPods may be limited if cata-
loging of iPod content is not completed. Cata-
loging of iPod content only occurs when the
system is in "AV Source" mode and the "iPod"
is the selected and displayed AV source. Cata-
loging of iPod content will not occur if the sys-
tem is off, if any other "AV Source" is selected
(aside from iPod), or if the system is in any
other mode (aside from "AV Source" mode)
such as "Destination" mode, "Contacts" mode,
"Settings" mode, "Phone" mode or "Map"
mode. If you wish to use Voice Control for all
iPod content, it is recommended that you first
connect your iPod, select "iPod" as the AV
source, and keep the iPod screen displayed
until cataloging is completed — cataloging of
iPod content should only take a few minutes,
and will depend on the size of the conent
stored on your iPod. A message will be dis-
played when cataloging is completed.
Touch [VR Catalog Mode] on the "AV
1
Settings" menu.
= For details, refer to Displaying the "AV Set-
tings" menu on page 95.
2 Touch [On] or [Off] to activate or deacti-
vate "VR Catalog Mode".
Chapter
13
97
En