Pioneer AVIC F500BT Operation Manual page 107

Appendix
The map color does not switch
automatically between daytime
and nighttime.
The screen is too bright.
The display is very dim.
No sounds of AV source are pro-
duced.
The volume level will not rise.
Adjusting the volume of naviga-
tion guidance and beeps is not
possible.
The person on the other end of
the phone call cannot hear the
conversation due to an echo.
There's no picture while this pro-
duct is attached on the cradle.
Nothing is displayed and the
touch panel keys cannot be
used.
There is no response when the
touch panel key are touched or
a different key responds.
Problems in the AV screen
Symptom
The screen is covered with the
caution message and the video
cannot be shown.
No video output from connected
equipments.
No video output from connected
iPod.
[Night mode] is set to [Day].
An improper value has been set on
"Brightness".
[Night] is selected in "Night
mode".
An improper value has been set on
"Brightness".
The volume level is low.
A speaker lead is disconnected.
You cannot adjust these with
MULTI-CONTROL.
The voice from the person on the
other end of the phone call is output
from the speakers and then picked
up by the microphone again, creat-
ing an echo.
The parking brake cord is not con-
nected.
The parking brake is not applied.
The backlight of the LCD panel is
turned off.
The setting for the rear view camera
is incorrect.
The shift lever was placed in [R]
when the rear view camera was not
connected.
The touch panel keys deviate from
the actual positions that respond to
your touch for some reason.
Cause
The parking brake lead is not con-
nected or applied.
The parking brake interlock is acti-
vated.
[AV Input] setting is incorrect.
The connection of the USB interface
cable for iPod is incorrect.
Check [Night mode] setting and make sure
[Automatic] is selected. (Page 81)
Check the settings.
Check the setting of [Night mode] and select
[Automatic] or [Day]. (Page 81)
Check the settings.
Adjust the volume level.
Check the connection.
Turn the volume up or down according to
[Sound settings] on the "Navi Settings"
menu. (Page 86)
Use the following methods to reduce the
echo:
—Lower the volume on the receiver
—Have both speakers pause slightly before
speaking
Connect the parking brake cord, and apply
the parking brake.
Connect the parking brake cord, and apply
the parking brake.
Turn on the backlight. (Page 95)
Select the appropriate setting for the rear
view camera.
Press MAP button, and then press MENU
button to return to the "Top Menu" and then
select the correct polarity setting for [Back
Camera]. (Page 92)
Perform the touch panel calibration. (Page
93)
Action (See)
Connect the parking brake lead correctly, and
apply the parking brake.
Park your vehicle in a safe place and apply
the parking brake.
Establish the setting correctly. (Page 78)
Connect both USB plug and mini-jack cable
side. (If only one connection has made, an
iPod will not work properly.) (Page 14)
Appendix
107
En