Configuring An Aggregation Group; Configuration Restrictions And Guidelines; Configuring A Static Aggregation Group - HPE FlexNetwork 5130 HI Series Configuration Manual

Tasks at a glance
(Optional.) Configuring load balancing for link aggregation group:
•
Setting load sharing modes for link aggregation groups
•
Enabling local-first load sharing for link aggregation
•
Configuring per-flow load sharing algorithm settings for Ethernet link aggregation
Enabling link-aggregation traffic redirection

Configuring an aggregation group

This section explains how to configure an aggregation group.

Configuration restrictions and guidelines

When you configure an aggregation group, follow these restrictions and guidelines:
•
You cannot assign a port to a Layer 2 aggregation group if any of the following features are
configured on the port:
MAC authentication. (See Security Configuration Guide.)
Port security. (See Security Configuration Guide.)
802.1X. (See Security Configuration Guide.)
•
If a port is used as a reflector port for port mirroring, do not assign it to an aggregation group.
For more information about reflector ports, see Network Management and Monitoring
Configuration Guide.
•
Removing an aggregate interface also removes its aggregation group and causes all member
ports to leave the aggregation group.
•
You must configure the same aggregation mode on the two ends of an aggregate link.
•
This switch series supports a maximum of 128 aggregation groups. To ensure the operation of
the service loopback groups, configure no more than 126 aggregation groups .

Configuring a static aggregation group

To guarantee a successful static aggregation, make sure that the ports at both ends of each link are
in the same aggregation state.
Avoid assigning ports to a static aggregation group that has reached the limit on Selected ports.
These ports will be placed in the Unselected state to avoid traffic interruption on the current Selected
ports. However, a device reboot can cause the aggregation state of member ports to change.
Configuring a Layer 2 static aggregation group
Step
Enter system view.
1.
Create a Layer 2 aggregate
2.
interface and enter Layer 2
aggregate interface view.
Exit to system view.
3.
Command
system-view
interface bridge-aggregation
interface-number
quit
43
Remarks
N/A
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation
numbered the same.
N/A
group