Faults And What To Do About Them - Bosch WAT Series Instruction Manual And Installation Instructions

Indicator
r is lit up
r is flashing
E 3 sec is lit up
E 3 sec is flashing
Û is flashing
Å is lit up
E:60 alternating with
- 2b and End
E:35 alternating with
- 10
E:36 alternating with
- 10
Other indicators

Faults and what to do about them.

Faults
Water is leaking from the
machine.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
Cause/remedy
Water pressure too low, may increase the length of the programme.
No water supply:
Turn the tap on fully,
■
The supply hose is kinked/trapped,
■
Clean the filter if necessary. ~ Page 35
■
The childproof lock is activated – deactivate it. ~ Page 30
The childproof lock is activated – the programme selector has been turned or the
control panel touched.
Run the Drum Clean Û 90 °C programme or a 60 °C programme to clean and
care for the drum and the outer tub.
Notes
Run the programme without laundry.
■
Use standard washing powder or a detergent that contains bleach. To prevent
■
foaming, only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents intended for woollens or delicates.
Switching the information signal on/off ~ Page 32
■
Too much foam has been detected and additional rinse cycles have been activated.
Add less detergent to the next wash cycle with the same load.
At the end of the programme.
Not an appliance fault – the unbalanced load detection system has interrupted the
spin cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum. Spin the laundry
again if necessary.
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service. ~ Page 39
The drain pump is blocked. Clean the drain pump. ~ Page 34
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
■
~ Page 35
Switch off the appliance, wait for five seconds and then switch it on again. If the indi-
cator appears again, call the after-sales service. ~ Page 39
Cause/remedy
Attach the drain hose correctly or replace it.
■
Tighten the threaded joint on the supply hose.
■
Will the programme start?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter.~ Page 35
■
Is the supply hose kinked or trapped?
■
Faults and what to do about them.
en
37