Ready In Time; Memory Programme - Bosch WAT Series Instruction Manual And Installation Instructions

Ready in time

After selecting a programme, the
programme duration is displayed, e.g.
1:51 (in h:min (hours:minutes)).
Before the programme starts, you can
move the time at which the programme
should be finished backwards, in
increments of 30 minutes and up to a
maximum of 24 h (h=hour).
After the programme starts, the
selected time, e.g. 8.5 h is displayed
and counted down until the washing
programme starts. The duration of the
programme is then displayed.
The programme duration is
Note:
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings, foam detection
function, unbalanced load detection, the
load or soiling may also change the
programme duration.
After the programme starts, and while
the selected time is counting down, you
can change this as follows:
Touch the control panel A.
1.
Touch N or M to change the time.
2.
And touch A again.
3.
After starting the programme, while the
programme is running, you can add or
remove laundry if necessary.
~ Page 30
Programme default settings

Memory programme

â
You can save a selected programme
with your favourite settings here.
To store:
Switch on the appliance.
1.
Select a programme.
2.
Change the settings and/or select
3.
additional settings.
Press and hold â on the control
4.
panel for approx. three seconds.
The programme is saved if all of the
settings flash briefly.
To use the saved programme, touch â
briefly after you switch on the appliance.
To change the saved programme, press
and hold â again for approx. three
seconds after selecting the new
settings.
en
25