Notes About Working And Operative Safety - Delta HD2105.2 Operating Manual

NOTES ABOUT WORKING AND OPERATIVE SAFETY

Authorized use
The technical specifications as given in chapter "TECHNICAL CHARACTERISTICS" must be ob-
served. Only the operation and running of the measuring instrument according to the instructions
given in this operating manual is authorized. Any other use is considered unauthorized.
General safety instructions
This measuring system is constructed and tested in compliance with the EN 61010-1:2010 safety
regulations for electronic measuring instruments. It left the factory in a safe and secure technical
condition.
The smooth functioning and operational safety of the measuring system can only be guaranteed if
the generally applicable safety measures and the specific safety instructions in this operating man-
ual are followed during operation.
The smooth functioning and operational safety of the instrument can only be guaranteed under the
environmental and electrical operating conditions that are in specified in chapter "TECHNICAL
CHARACTERISTICS".
Do not use or store the product in places such as listed below:
• Rapid changes in ambient temperature which may cause condensation.
• Corrosive or inflammable gases.
• Direct vibration or shock to the instrument.
• Excessive induction noise, static electricity, magnetic fields or noise.
If the measuring system was transported from a cold environment to a warm environment, the for-
mation of condensate can impair the functioning of the measuring system. In this event, wait until
the temperature of the measuring system reaches room temperature before putting the measuring
system back into operation.
Obligations of the purchaser
The purchaser of this measuring system must ensure that the following laws and guidelines are ob-
served when using dangerous substances:
EEC directives for protective labour legislation
National protective labour legislation
Safety regulations
HD2105
- 34 -
V2.3