Operating With A Key-Chain Remote - Nemtek AGRI Instruction Manual

AGRI
AGRI Solar
Operating the energizer with a Nemtek key-chain remote is the same as for operating the
energizer without a remote, except that, if the energizer has been locked, then at power on,
the Nemtek key-chain remote will have to be presented to the energizer before it begins
operating.
To present a remote to the energizer, perform these following steps;
• Turn the Nemtek key-chain remote on as discussed in the previous section.
• Be sure you have activated the menu and not the torch.
• Hold the remote such that the
Nemtek
• Keep the remote in place for a second or two, after which you should hear a short
beep from the energizer indicating successful completion of a transaction. If instead a
long beep is heard, then the energizer has been locked with a different pin to that
contained in the remote you are using. If no beep sound is heard, slowly move the
remote over the face of the energizer in the vicinity of the Nemtek
• On hearing the beep, you can move the remote away from the energizer and a new
energizer menu will appear on the display of the remote, through which you can start
navigating.
The energizer menu:
Menu Lower
item limit
Supply -
information
Fence -
Effort -
Set Off / 2 kV
Rate 1 second
Set Off / 2 kV
Rate 1 second
Warn at 60%
Control -
Locked -
V min -
% max -
logo on the front of the energizer (see drawing on page 13).
Upper
limit
-
-
-
10 kV
4 second
10 kV
4 second
95%
-
-
-
-
Operating with a
key-chain remote
symbol near the top right of the remote is over the
Factory Description
default
-
Battery/mains supply voltage
-
Present fence operating voltage
information
-
Energizer effort or capacity being
used, at present, to drive the fence
at the set voltage.
8 kV
Fence day light set point voltage
1.5 second
Fence day light set pulse rate
8 kV
Fence night set point voltage
1.5 second
Fence night set pulse rate
95%
Energizer effort threshold at which
the high intensity warning light
begins to double flash
APT
Fence voltage Conventional or
Adaptive control method
No
Nemtek energizer security lock
function enable or disable
-
Lowest recorded fence voltage
(reset after remote presentation)
-
Highest recorded fence effort
(reset after remote presentation)
14
logo.