Table of Contents
Advertisement
Chapter 5 -Troubleshooting
Problem
The SpaceLink Access Point Manager still cannot find or connect
to the SpaceLink Access Point after verifying the IP address and
LAN cable, changes cannot be made, or password is lost.
Solution
In case the SpaceLink Access Point is inaccessible, you can
restore the SpaceLink Access Point's factory default settings.
Use a straightened paper clip to press the button located in
the hole labeled "Reset" on the back of the SpaceLink Access
Point and keep it depressed over 5 seconds. The amber power
LED will darken and then light up when reset is successful.
Reset to Defaults
The following are factory default values. These values will be present when you
first receive your SpaceLink Access Point, if you push the reset button on the
back of the SpaceLink Access Point over 5 seconds, or if you click the "Reset to
Defaults" on the "General" page of the SpaceLink Access Point Manager.
Name
Password
IP address assignment
Primary port
IP address
Subnet mask
Gateway
SSID
Channel
WEP type
AP name
Operational mode
Only allow IP packets
Authorization table
Host AP / Wireless Bridge MAC Add.
Fragmentation threshold
RTS threshold
Preamble mode
Authentication type
46
192.168.39.130
Disable
2346
Long preamble
ASUS SpaceLink 802.11g Access Point
Default Value
"asus"
obtain an IP address automatically
Ethernet
255.255.255.0
0.0.0.0
"default"
1
WEP disable
"ASUS AP"
AP mode
Disable
00-00-00-00-00-00
2346
Both
Advertisement
Table of Contents
