Checking Spark Plug (See Fig 14)
•
Disconnect the spark plug cap from the spark plug.
•
Before removing the spark plug, clean the area around its base to prevent debris from entering the engine.
•
Remove the spark plug with a comerically available13/16 spark plug wrench
•
Inspect spark plug. Replace if electrodes are worn or if the insulator is cracked or chipped.
•
Clean carbon deposits off the electrode with a wire brush.
•
Check the electrode gap with a suitable gauge and slowly adjust to 0.7 - 0.8 mm if necessary.
•
Reinstall spark plug and tighten to Torque 22.0 – 26.9 Nm (16-20 ft-lb).
•
Reconnect spark plug cap.
•
If spark plug is worn replace only with an equivalent replacement part. Recommended spark plug: F7TC.
•
Spark plug should be replaced annually.
A spark plug that is too loose can overheat and damage engine. A spark plug that is too
CAUTION!
tight can damage threads of the cylinder head.
MAINTENANCE
SPARK PLUG CAP
SPARK PLUG WRENCH
FIG 14
17
0.7 - 0.8 mm