JVC KD-G401 Service Manual page 4

3.1.4 Removing the side panel
(See Fig.4)
• Prior to performing the following procedure, remove the front
panel assembly as required.
(1) Remove the screw B and two screws C attaching the side
panel on the left side of the main body, and remove the side
panel.
3.1.5 Removing the rear bracket
(See Fig.5)
• Prior to performing the following procedure, remove the bottom
cover.
(1) Remove the three screws D, two screws E and screw F
attaching the rear bracket on the back side of the main
body.
(2) Remove the rear bracket.
Reference:
Insert the STEERING cable into the slot before attaching the
rear bracket to the main body.
3.1.6 Removing the main board
(See Figs.5 and 6)
• Prior to performing the following procedures, remove the front
panel assembly, bottom cover and side panel.
• Remove the front chassis assembly as required.
(1) Remove the three screws D attaching the rear bracket on
the back side of the main body. (See Fig.5.)
(2) Remove the two screws G attaching the main board. (See
Fig.6.)
(3) Disconnect the connector
the main body and take out the main board with the rear
bracket. (See Fig.6.)
Reference:
Remove the rear bracket from the main body as required. (See
"3.1.5 Removing the rear bracket".)
CN501 on the main board from
B
C
Side panel
Fig.4
Insert STEERING cable into the slot.
D
E F E
Fig.5
CN501
G
Fig.6
C
Rear bracket
D
D
Main board
G
Rear bracket
(No.MA051)1-7