JVC KD-G401 Service Manual page 13

Cd receiver

Hide thumbs Also See for KD-G401:

Enlarged version

3.2.9 Removing the trigger arm

(See Figs.19 and 20)

• Prior to performing the following procedure, remove the top

cover, connector board and clamper unit.

(1) Turn the trigger arm in the direction of the arrow to release

the joint k and pull out upward.

CAUTION:

When reassembling, insert the part m and n of the trigger

arm into the part p and q at the slot of the chassis rivet

assembly respectively and join the joint k at a time.

3.2.10 Removing the top plate assembly

(See Fig.21)

• Prior to performing the following procedure, remove the top

cover, connector board, chassis unit, and clamper assembly.

(1) Remove the screw H.

(2) Move the top plate assembly in the direction of the arrow to

release the two joints r.

(3) Unsolder the wire marked s if necessary.

1-16 (No.MA051)

Chassis rivet assembly

Fig.19

Trigger arm

Part m

Chassis rivet

assembly

Fig.20

Top plate assembly

Fig.21

Joint k

Trigger arm

Part p

Part q

Part n

Joints r

Table of Contents

Kd-g401 e Kd-g401 ex