Husqvarna 122 HD60 Workshop Manual page 49

Crankshaft and crankcase
Assemble the piston.
Attach the fl ywheel.
502 50 70-01
Fit the cylinder on the crankcase.
502 50 70-01
502 71 27-01
Put the cylinder base gasket in place
either in the crankcase or cylinder base.
Assemble the piston on the connecting
rod.
Tip!
Fit both spacer washers between the
piston and the needle bearing with a little
grease to facilitate assembling.
Check that the piston is turned so the
arrow points towards the exhaust port.
Make sure that the gudgeon pin retaining
rings are fi tted correctly in the slots by
twisting them with a fl at nosed pliers.
Attach the fl ywheel.
Lubricate the piston and piston rings with
a few drops of oil.
Fit the cylinder on the crankcase.
Use the piston ring compressor and
carefully slide the cylinder into position.
Tighten the 2 screws.
Assemble the remaining parts in the
reverse order as set out for dismantling.
See relevant sections in the manual.
7
47