Installation; [A] Storage Bin; [B] Multi Compressor Rack System - Hoshizaki FM-1200ALKE Instruction Manual

ENGLISH
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. D o n o t p l a c e a n y t h i n g o n t o p o f t h e
icemaker or in front of the louver.

3. INSTALLATION

* Incorrect installation can cause harm to people,
animals or things, for which the manufacturer
cannot be held responsible.

[a] STORAGE BIN

1) Fully screw in the four legs provided (bin
accessory) into the storage bin underside. See
Fig. 3.
Adjustable Legs
2) P o s i t i o n t h e s t o r a g e b i n i n t h e s e l e c t e d
permanent site.
3) Remove the tape from the chute opening at the
bottom of the icemaker.
4) Pull down the end of the string coming out of the
chute opening to remove the cushion.
Note: If the power supply is turned on with the
cushion left inside, the icemaker will not start
showing "BIN FULL" in the display.
Bottom Plate
Fig. 3
Tape
Fig. 4
5) Place the icemaker on top of the storage bin by
holding the bottom.
6) Secure the icemaker to the storage bin, by
using the two mounting brackets and two bolts
provided. See Fig. 6.
Bolt
Mounting
Bracket
7) Seal the seam between the
icemaker and the storage bin
with food grade sealant.
8) Refit the side panels in their
correct position.
9) Adjust the four legs on the
bottom (adjustable from 0 to
25.4 mm) to have the icemaker
perfectly horizontal. Use the
spirit level. See Fig. 7.

[b] MULTI COMPRESSOR RACK SYSTEM

Use an appropriate condensing unit such as:
FM-1200ALKE(-N)
OP-LCHC096NTA02 by DANFOSS
Evaporating temperature: -25°C 3560W
FM-1800ALKE(-N)
OP-LCHC136NTA02 by DANFOSS
Evaporating temperature: -25°C 5430W
4
String
Fig. 5
Icemaker
Bin
Fig. 6
Adjust legs
Fig. 7