Assembly - Bissell 1739 SERIES User Manual

Assembly

WARNING
Do not plug in your vacuum until you are familiar with all instructions and operating
procedures.
The only tool you will need to assemble
your vacuum is a Phillips screwdriver.
1
Place the upper
handle onto the
base and push
it down. Then
attach the handle
with the 2 screws
that are taped to
the handle in a
plastic bag.
To experience freshness
3
as you vacuum, locate
the Febreze® scent tag
at the bottom of the
vacuum bag. Carefully
pull the tab along the
perforated lines in the
center of the scent tag.
NOTE: Only a portion of
the overwrap should be
removed.
5
NOTE: The crevice tool can be found inside the extension wand. You can remove
it to use it and put it back to store it neatly out of your way when you're finished.
Now wrap
the hose
through the
hose clip
and connect
the hose
wand to the
foot hose
down at the
bottom of
the vacuum.
2
4
Next, insert the end of the hose into the back
of the vacuum and twist to lock it into place.
Put your accessory tools on the
vacuum and you're ready to go!
Extension Wand
(with Crevice Tool inside)
Wrap the power
cord around the
cord wraps and
clip the end of
the plug to the
power cord.
Dusting Brush
www.BISSELL.com
5