Power Washer - Mercedes-Benz GLE Operator's Manual

Care
320
!
In car washes with a towing mechanism,
make sure that the automatic transmission is
in transmission position N, otherwise the
vehicle could be damaged.
Vehicles with a SmartKey:
R
Do not remove the SmartKey from the igni-
tion lock. Do not open the driver's door or
front-passenger door when the engine is
switched off. Otherwise, the automatic
transmission selects park position P auto-
matically and locks the wheels. You can
prevent this by shifting the automatic trans-
mission to N beforehand.
Vehicles with KEYLESS-GO:
R
Do not open the driver's door or front-
passenger door when the engine is
switched off. Otherwise, the automatic
transmission selects park position P auto-
matically and locks the wheels.
Observe the following to make sure that the
automatic transmission stays in position N:
Make sure the vehicle is stationary and the
X
ignition is switched off.
Turn the SmartKey to position 2 in the ignition
X
lock ( page 132).
Y
Use the SmartKey instead of the Start/Stop
button on vehicles with KEYLESS-GO.
Depress and hold the brake pedal.
X
Shift the automatic transmission to position
X
N.
Release the brake pedal.
X
Release the electric parking brake.
X
Switch off the ignition and leave the SmartKey
X
in the ignition lock.
You can wash the vehicle in an automatic car
wash from the very start.
If the vehicle is very dirty, pre-wash it before
cleaning it in an automatic car wash.
After using an automatic car wash, wipe off wax
from the windshield and the wiper blades. This
will prevent smears and reduce wiping noises
caused by residue on the windshield.
Washing by hand
In some countries, washing by hand is only
allowed at specially equipped washing bays.
Observe the legal requirements in all countries
concerned.
Do not use hot water and do not wash the
X
vehicle in direct sunlight.
Use a soft sponge to clean.
X
Use a mild cleaning agent, such as a car
X
shampoo approved by Mercedes-Benz.
Thoroughly hose down the vehicle with a gen-
X
tle jet of water.
Do not point the water jet directly towards the
X
air inlets.
Use plenty of water and rinse out the sponge
X
frequently.
Rinse the vehicle with clean water and dry
X
thoroughly with a chamois.
Do not let the cleaning agent dry on the paint-
X
work.
When using the vehicle in winter, remove all
traces of road salt deposits carefully and as
soon as possible.
Power washers
G
WARNING
The water jet from a circular jet nozzle (dirt
blasters) can cause invisible exterior damage
to the tires or chassis components. Compo-
nents damaged in this way may fail unexpect-
edly. There is a risk of an accident.
Do not use power washers with circular jet
nozzles to clean the vehicle. Have damaged
tires or chassis components replaced imme-
diately.
!
Always maintain a distance of at least
11.8 in (30 cm) between the vehicle and the
power washer nozzle. Information about the
correct distance is available from the equip-
ment manufacturer.
Move the power washer nozzle around when
cleaning your vehicle.
Do not aim directly at any of the following:
Tires
R
Door gaps, roof gaps, joints, etc.
R
Electrical components
R
Battery
R
Connectors
R
Lamps
R
Seals
R
Trim
R
Ventilation slots
R