Synchronizing The Rolling Code - Mercedes-Benz GLE Operator's Manual

Programming
Programming buttons
Pay attention to the "Important safety notes"
( page 310).
Y
Garage door remote control A is not included
with the integrated garage door opener.
Turn the SmartKey to position 2 in the ignition
X
lock ( page 132).
Y
Select one of buttons ; to ? to use to con-
X
trol the garage door drive.
To start programming mode: press and
X
hold one of buttons ; to ? on the integrated
garage door opener.
The garage door opener is now in program-
ming mode. After a short time, indicator
lamp : lights up yellow.
Indicator lamp : lights up yellow as soon as
button ;, = or ? is stored for the first time.
If the selected button has already been pro-
gramed, indicator lamp : will only light up
yellow after ten seconds have elapsed.
Release button ;, = or ?. Indicator
X
lamp : flashes yellow.
To program the remote control: point
X
garage door remote control A towards but-
tons ; to ? on the rear-view mirror at a dis-
tance of 2 to 8 in (5 to 20 cm).
Press and hold button B on remote control
X
A until indicator lamp : lights up green.
When indicator lamp : lights up green: pro-
gramming is finished.
When indicator lamp : flashes green: pro-
gramming was successful. The next step is to
synchronize the rolling code (
Release button B on remote control A for
X
the garage door drive system.
If indicator lamp : lights up red: repeat the
programing procedure for the corresponding
button on the rear-view mirror. When doing
so, vary the distance between remote control
A and the rear-view mirror.
The required distance between remote con-
trol A and the integrated garage door opener
depends on the garage door drive system.
Several attempts might be necessary. You
should test every position for at least
25 seconds before trying another position.

Synchronizing the rolling code

Pay attention to the "Important safety notes"
( page 310).
Y
If the garage door system uses a rolling code,
you will also have to synchronize the garage
door system with the integrated garage door
opener in the rear-view mirror. To do this you will
need to use the programming button on the door
drive control panel. The programming button
may be located in different places depending on
the manufacturer. It is usually located on the
door drive unit on the garage ceiling.
Familiarize yourself with the garage door drive
operating instructions, e.g. under "Program-
ming additional remote controls", before carry-
ing out the following steps.
Your vehicle must be within reach of the garage
door or gate opener drive. Make sure that nei-
ther your vehicle nor any persons/objects are
present within the sweep of the door or gate.
Turn the SmartKey to position 2 in the ignition
X
lock (
Get out of the vehicle.
X
Press the programming button on the door
X
drive unit.
Usually, you now have 30 seconds to initiate
the next step.
Get into the vehicle.
X
Press previously programed button ;, =
X
or ? on the integrated garage door opener
repeatedly and in quick succession until the
door closes.
The rolling code synchronization is then com-
plete.
Notes on programming the remote con-
trol
Canadian radio frequency laws require a "break"
page 311).
Y
(or interruption) of the transmission signals
after broadcasting for a few seconds. Therefore,
these signals may not last long enough for the
integrated garage door opener. The signal is not
recognized during programming. Comparable
page 132).
Y
Features
311
Z