JVC KA-MR100G Service Manual page 6

(4) Disconnect the wires from each connector CN13,
the CODEC board.
(5) Remove the four screws E attaching the CODEC board,
and then remove it.
NOTE:
Be careful not to damage the CN28 when
removing or attaching the CODEC board.
(6) Remove the four screws F attaching the SxS board, and
then remove it.
1-6 (No.HC027<Rev.001>)
CN21
E
CN21
CN13
CODEC Board
E
Fig.5
F
SxS Board
F
Fig.6
on 3.1.3 Removing the guide unit (See figure 7, figure 8, figure
9)
• Remove the SxS board.
(1) Remove the two screws G attaching the guide unit with
SxS board.
SxS Board
(2) Remove the guide unit from the SxS board by sliding the
guide unit to the direction of the arrow.
NOTE:
Attention at installation.
Locked surely
G
G
Fig.7
Guide unit
Fig.8
Come into contact
Fig.9