5.1.6 Mount KA-MR100G
(1) Connect Battery cable.
(2) Attach KA-MR100G to KA-UM100G.
Push the bottom side of KA-MR100G to be locked.
(3) Tighten two screws.
5.1.8 Set the [INT/EXT] switch to "INT"
Note.
After this modification, the IEEE1394 connector of
KA-UM100G becomes no communication available.
Fig.16
Fig.17
Fig.18
Set to INT
No communication available through IEEE1394 terminal of KA-UM100G
(4) Install the rubber sheet.
5.1.7
Install the Battery mount plate
(1) Connect Battery cable and Battery INFO cable.
Note.
The connector should be placed to the
bottom space.
(2) Tighten four screws.
Fig.19
Fig.20
Fig.21
(No.HC027<Rev.001>)1-13